DJI How to install Naza M V2 on F450



DJI adheres to continuous innovation and improvement. With the new firmware, new attitude stabilization algorithm and optimized hardware structure, the Naza-M V2 provides better flight performance. The innovative All-in-one design simplifies installation and saves space and weight. It contains inner damping, controllers, 3-axis gyroscope, 3-axis accelerometer and barometer in its light and small Main Controller. It can measure flying altitude and attitude and therefore can be used for…

20 Comments

  1. With all this continuous innovation and improvement why can't you make it work in Windows 10?

  2. Hi DJI, how do I have images of the drone f450 camera on the same phone as the Phantom, would it be possible to use the phantom wifi extender on the f450? … Thank you

  3. No information on the configuration or setup of this stupid flight control system. It does not work as easy as plug and play. In fact the setup assistant does not assist you on how to set it up!

  4. how much does it matter that the gps antenna be mounted on the post as opposed to mounting it on the copter itself?

  5. Erm, typically the white is forwards direction, and the bottom plate is the wrong way around. Otherwise you get sideways mounted gimbal.

  6. You are an absolute Legend for this.. Very straight and concise set of instructions. Even the actual manual is not this clear about mounting. Thank you!

  7. Gee the flight controller and GPS/compass module were nearly pointing forwards.

  8. is the arrow on the gps compass supposed to be pointed towards the main controller?, or to the front of the quad?,, or facing the regional magnetic deviation? this seems to be a common question i cant find the correct answer to.
    DJI please respond!
    thanks you for your time!!!
    :
    Latitude: 43° 31' 7.2" N
    Longitude: 79° 52' 47.3" W
    Magnetic declination: -10° 7'
    Declination is NEGATIVE (WEST)
    Inclination: 69° 52'
    Magnetic field strength: 54109.5 nT

  9. why install the pmu way out there on one of the motors- surely keping all the mass in the middle near the cg is best ?

  10. Ok guys I have NAZA M v2 and Turnigy Multistar 45 Amp OPTO Controller on my hexa, can anybody tell me should I remove the red wire (+) from the controller or not?

  11. he doesn't even really have them on straight lol all that money and you higher someone dyslexic

  12. Yep… I just did a F350 build following the DJI videos and realised they have the plate all messed up… !!! Thanks for telling us DJI!!!

Leave a Reply

Your email address will not be published. Required fields are marked *